Managing ion concentration in sap to control drying collapse, permeability, and streaming potential in plantation-grown eucalyptus timber
Vikash Ghildiyal, Clemens Michael Altaner, Bill Heffernan
10 lipca 2024 · Sustainable materials and technologies
Streszczenie
Brak zatwierdzonego streszczenia. Przeczytaj abstrakt poniżej lub otwórz oryginalną publikację.
Abstrakt
Wood is an important renewable resource for a future sustainable bioeconomy. Ion-mediated response in wood is considered a major factor in sap-flow regulation. This study examined the influence of sap replacement with KCl solution and deionised water on drying collapse, wood permeability, and streaming potential of never-dried wood. Volumetric and tangential collapse in KCl-treated Eucalyptus nitens logs decreased significantly by 42%–62% and by 51%, respectively. Improvement in shrinkage properties was concentration-dependent, with a maximum at a concentration (20 mM) in the range of total ionic strength found in living trees. Logs treated with deionised water showed higher normal shrinkage, without affecting collapse. Consistent with reduced collapse in KCl-treated logs, eucalyptus stem cores showing low collapse contained significantly more inorganic cations than the high-collapsed wood. The decrease in collapse when treated with KCl solution coincided with increased green wood permeability. Sap conductivity affected the streaming potential, with the polarity of the induced electric potential varying between concentrations and matching literature reports of electric potential measurements in living trees and laboratory experiments. This study confirmed that drying collapse was negatively correlated to sap conductivity, and potential technological solutions to drying collapse in E. nitens could include sap replacement as a pre-drying treatment, and/or nutrient management of the plantations.
Abstrakt w wersji dostarczonej przez źródło. Pełny tekst może być ograniczony przez wydawcę.
Powiązane publikacje
Predicting the mechanical properties of sawn timber: Basic non-destructive tools applicable to Norway spruce sawlogs
1 wrz 2026 · Rostislav Berezjuk, Matěj Šimek, Robert Mařı́k i in. · Central European Forestry Journal
Evaluation of Wood Processing in the Sawmilling Industry in Ekiti State, Nigeria
1 lip 2025 · Ademola Ayodeji Omoyeni, Timileyin Samuel Oguntuase · International Journal of Advances in Engineering and Management
Mechanical properties of sweet chestnut sawn wood and glulam performance
15 maj 2025 · Carlos Eduardo de Jesus Martins, Cláudio Ferreira, Sandra R. S. Monteiro i in. · European Journal of Wood and Wood Products
Moisture-induced timber joining - Utilizing the hygroscopicity and shape-memory effect of wood resulting in dimensional change in a prefabricated wood-only, self-built, sawn timber system for affordable housing in Colombia
1 mar 2024 · Max Salzberger, Juan Sebastian Cruz Rojas, Gilbert Koskamp · Research Square