Structural investigation of wood-inspired cell wall geometries using additive manufacturing: Compression testing and finite element analysis validation

Streszczenie

Brak zatwierdzonego streszczenia. Przeczytaj abstrakt poniżej lub otwórz oryginalną publikację.

Abstrakt

Mechanical properties of wood-inspired cell wall geometries were considered through compression testing and Finite Element Analysis (FEA) with ANSYS simulation. Six models, including earlywood, latewood, and various array configurations, were fabricated via 3D printing using acrylonitrile butadiene styrene (ABS) filament. Compression tests highlighted the annual ring model’s robustness, exhibiting a maximum load of 12707 MPa, while the 4×3 matrix displayed the lowest strength at 4247 MPa. Shifting rows led to reduced strength, which was particularly evident in vertical prints. An analysis of variance revealed significant differences in mechanical properties. Discrepancies between experimental tests and FEA results ranged from -45.9% to 35.2%. Earlywood exhibited a maximum deformation of 2.6 mm, whereas latewood showed lower deformation, indicating geometry’s influence on material behavior. Mesh quality remained consistent, ensuring dependable simulation outcomes. These findings underscore the pivotal role of geometry in compression resistance, laying the groundwork for future studies on wood densification mechanisms and the development of customized wood composites.

Abstrakt w wersji dostarczonej przez źródło. Pełny tekst może być ograniczony przez wydawcę.