Evaluation of the tensile strength of Korean yellow poplar lumber

Summary

No reviewed summary yet. Read the abstract below or open the original publication.

Abstract

This study was conducted to confirm the feasibility of using yellow poplar, which is a fast-growing hardwood species in Korea, as a structural material. Lumber was produced, and the mechanical grading and the knot diameter ratio on the wide surface measurement were performed for each grade of lumber. It was confirmed that the majority mechanical grades of yellow poplar were E10, E11, and E12, and the size of knot in the surface increased as the mechanical grades decreased. A fitted distribution of tensile strength of the lumbers was the Weibull distribution. As a result of calculating the tensile allowable stress using the 5th percentile value calculated by the Weibull distribution and the non-parametric method according to the mechanical grade, all the experimental values were higher than the minimum allowable stresses presented in the Korean industrial standards. However, for the low grades, there was no significant difference from the standard values. This was thought to be due to the large size of knots in low-grade lumber. It was expected that the prospect of using yellow poplar structural member will be higher if additional research is conducted on the restriction of knot size according to the mechanical grade.

Abstract as supplied by the source. Full text may be restricted by the publisher.