Variability of Properties of Wood Biomass Combustion Waste During the Heating Season in the Context of Their Environmental Use

Summary

No reviewed summary yet. Read the abstract below or open the original publication.

Abstract

The use of wood chips in the heating sector leads to the generation of combustion waste with variable properties, which poses challenges for their rational management. To determine the variability of combustion waste, samples were collected over a 13-week period during the heating season, as weekly aggregate samples from a biomass bioheating plant burning wood chips. Three waste fractions were obtained for analysis: residue from the grate (B1), dust from the dust collector (B2), and boiler dust (B3). Dry matter (DM), reaction (pHKCl), electrolytic conductivity (EC), content of total carbon (TC), total nitrogen (TN), macronutrients (P, K, Mg, Ca, Na), and heavy metals (Fe, Mn, Zn, Cu, Pb, Cd, Cr, Co, Ni) were determined in the collected samples. All waste fractions were characterized by an alkaline reaction. Regardless of the waste fraction, the macronutrient content was dominated by Ca, K, and Mg, with significantly lower levels of P and Na. Among heavy metals, Fe, Mn, and Zn had the highest recorded contents, and the lowest by far was Cd. With respect to sampling dates, the least diversified chemical composition was observed for B1 samples, more diversified for B2, and the most diversified for B3. In turn, regardless of the waste fraction, the most diversified results were observed for Cd and Pb, and the least for pH, DM, and TC. Concerning environmental management of combustion waste, fraction B1 deserves attention, as it was characterized by the richest chemical composition (TN, P, K, Mg, Ca, Na, Mn, Zn, Cu, Co, Ni). However, due to the highest content of undesirable heavy metals (Pb, Cd) and the highest salinity, it requires constant monitoring of the composition.

Abstract as supplied by the source. Full text may be restricted by the publisher.